Page 1 of 1
Sections
Posted: Thu Jan 29, 2009 1:50 am
by lanternz
How can I make the section view sit higher in the window? I can trick it by entering a position with a negative height but I can't seem to do that with a graphic line. This would be handy to indicate a sub-floor or orchestra pit. It does not seem to adjust to the height of an imported graphic of a section from VW2008 for example.
Posted: Fri Jan 30, 2009 5:53 pm
by admin
LXFree looks at the 3D locations of objects to set the size of the section view. By default, zero height is used for the lower border. So, you are correct that in order to have it display negative heights, you need to include an object with a negative location.
Posted: Sat Jan 31, 2009 12:52 am
by lanternz
Can you make it so that this can be something other than a position? Seems confusing to have to put in dummy positions to read the drawing. The issue in particular is that I have imported a section drawing of the theatre and I can't see the little chap sitting in the front row properly. The section view truncates the imported section layer to the zero point of the drawing.