Version 3.5 Wedged?
Posted: Tue May 20, 2014 7:50 pm
Hi all:
I just prompted to instal new version 3.5.0 (8915A) and I dutifully installed in mid-design. Now my section view is all broken - The lines I sketched into the section (proscenium side view, acting area centers, dimensions) are all offset 20' or so to the right (viewing from stage R to the centerline). The upstage-downstage ruler in the Section view is even more off than before -- in the plan view, the plaster line is 0'-0" on the Y-axis; the centerline is 0'-0" on the X-axis and all my positions, borders, and legs are drawn off that reference. However, the section now shows the legs et al. 20' further US than the plot and my measurement and sightlines are all shifted 30' DS relative to 0.
What's up? Is this version not ready for prime time?
-luke
I just prompted to instal new version 3.5.0 (8915A) and I dutifully installed in mid-design. Now my section view is all broken - The lines I sketched into the section (proscenium side view, acting area centers, dimensions) are all offset 20' or so to the right (viewing from stage R to the centerline). The upstage-downstage ruler in the Section view is even more off than before -- in the plan view, the plaster line is 0'-0" on the Y-axis; the centerline is 0'-0" on the X-axis and all my positions, borders, and legs are drawn off that reference. However, the section now shows the legs et al. 20' further US than the plot and my measurement and sightlines are all shifted 30' DS relative to 0.
What's up? Is this version not ready for prime time?
-luke