Original LXSeries Forum

I had nearly completed a drawing and found I needed to shift the drawing in the paper space. I then reset the drawing origin point to 0 at the setting line and centre line. Now I find the all the mapped position information still refers to the original drawing position. Is it possible for the mapped information to always refer to the 0 point of the drawing? Or is there some rationale for the retention of the original mapped point?

This was an oversight when the preference to move the focus along with the origin was added. v5.5.3 now corrects this. Make sure the "Origin change moves focus and mapped points" box is checked in the focus tab of the preferences before moving the origin.