Page 1 of 1
curved positions
Posted: Fri May 27, 2011 5:10 am
by lanternz
I thought that "convert line to position" might work to make a curved lighting position as found in many front of house bridges but it does not seem to do this. Is there someway to get a curved lighting position?
Posted: Tue May 31, 2011 9:46 pm
by admin
In 1.9.6 (5331) is is possible to convert a curved line or a path object into a position.
These path type positions always layout from the start point of the path. If you map a path type position , the mapping of symbols attached to the position is based on the offset of the start point to the mapped start point.