I am trying to see if I can use LXConsole and the Enttec DMX USB Pro as an alternative to taking a light board on tour. Of course, I want to make sure it is a viable solution before I leave, so I set it up with a small dimmer pack (Elation DP 415) and a couple MR16s. It works fine on a one to one patch, but I can't seem to get an edit to the patch to work. Whether I clear the patch, input my own patch, or select one to one patch, it always acts like a one to one patch. I am editing the patch in the channel table in the bottom of the main window, and reseting the patch in the set up window. Am I missing something?
I am using the latest version of LXConsole (2.2.0(4603)) with a OSX 10.6.8 on an Intel Core Duo MacBook Pro.
Any suggestions or comments would be appreciated!
patching with Enttec USB pro
found the answer to my own question
Poking around the forum, I found that I should look and see if the "send channels" box is checked in the DMX Out preference. It was. When I unchecked it, I could patch. Hope this helps others who may get stuck in the same way.