Original LXSeries Forum

I am trying to see if I can use LXConsole and the Enttec DMX USB Pro as an alternative to taking a light board on tour. Of course, I want to make sure it is a viable solution before I leave, so I set it up with a small dimmer pack (Elation DP 415) and a couple MR16s. It works fine on a one to one patch, but I can't seem to get an edit to the patch to work. Whether I clear the patch, input my own patch, or select one to one patch, it always acts like a one to one patch. I am editing the patch in the channel table in the bottom of the main window, and reseting the patch in the set up window. Am I missing something?
I am using the latest version of LXConsole (2.2.0(4603)) with a OSX 10.6.8 on an Intel Core Duo MacBook Pro.
Any suggestions or comments would be appreciated!

Poking around the forum, I found that I should look and see if the "send channels" box is checked in the DMX Out preference. It was. When I unchecked it, I could patch. Hope this helps others who may get stuck in the same way.