Original LXSeries Forum

Hey there,

so I'm recording cues in tracking mode, using the groups-shortcut (capital "G"). Everythings fine until I want to set a group in a cue to 0.
What I type in is: "Group: 65@z" or "Group: 65@00". In both cases I see the level in the Advanced-Drawer disappear and thus the in the group included channels jump to FL (because I removed the boundary for that group!?).
If I now manually type "65@0" in the Advanced-Drawer and hit "Update" I get the desired result.

Is there a correct way of achieving the behavior I want?

Greetings
Jan

There appears to be a problem with entering a zero level for a group through the command line. There may be a reason for this that is not an error.

So, at least for now, to set an included group to zero, you need to use cues mode and type the group@0 into the advanced tab directly.

It is possible to set a Group@00 from the command line in the latest build 4.0.1 (9402.1)

No… you didn't just…
Thank you!