Page 1 of 1
LXNet2OpenDMX
Posted: Thu Jan 12, 2017 10:24 pm
by admin
Hi Claude! Thank you so much for your LXNet2OpenDMX Software. However I managed only the sANC protocol to get working. How to I have to config my ArtNet settings in LXConsole? Am I supposed to the LXNet2OpenDMX as an ART-Net node? thank you.
Posted: Thu Jan 12, 2017 10:24 pm
by admin
Yes, the LXNet2OpenDMX application acts as an Art-Net node. In the latest build of LXConsole there's a button to show the detected Art-Net nodes in the DMX Out tab of the preferences.
If you run the LXNet2OpenDMX application, turn on Art-Net output in the DMX Out tab of the preferences, and enable Ethernet (File->External->Ethernet), you should see both the LXConsole Application itself and the LXNet2OpenDMX listed in the Art-Net nodes window.
Earlier versions of LXConsole, you can probably set to unicast Art-Net to 127.0.0.1 and you should see that LXNet2OpenDMX is receiving Art-Net (the indicator will flash blue then green).