New Symbol
New Symbol
I would greatly appreciate the introduction of a symbol for a short (cut off) PAR 64. Unless of course it is already there and I have missed it!
If you are looking for SourceFour PARs, they are in the ETC key.
If you are looking for conventional PAR's in a short body fixture, they are added in the PAR key in version 0.9.1607
Version 0.9.1607 adds alternate conventional PAR symbols that are slightly smaller than the standard ones (but more true-to-scale size). There is also a short body variation of this set. (also scale size).
If you are looking for conventional PAR's in a short body fixture, they are added in the PAR key in version 0.9.1607
Version 0.9.1607 adds alternate conventional PAR symbols that are slightly smaller than the standard ones (but more true-to-scale size). There is also a short body variation of this set. (also scale size).
Short PAR Cans
Many thanks for that information. I had not got the latest version so an upgrade has revealed all. It was the conventional PAR that I was seeking. As I work with this software I am becoming more and more enthusiastic about it.