Hi all !!!
I'd like to know how to align my centre line with the 0 of the ruler.
https://www.dropbox.com/s/im965uldcomi3 ... 3.png?dl=0
Thanks and have a good day !
Pascal
Center line at center ruler
There are several ways to do this. Perhaps the most direct is to use the popup in the toolbar. Select NextClick sets->Origin. Click on the drawing at the location you want (0, 0) to be.
There is also the Document tab of the Inspector. Looking at Coordinates, you can directly set where the origin is from the lower left corner of the drawing. There is also a popup with commands that allow you to center it vertically and horizontally. You can also set the origin to the center of the selection.
In your dropbox image, the center line is selected. You can simply navigate to Documents/Coordinates and use the Set Origin popup to center the origin on the middle of this line.
There is also the Document tab of the Inspector. Looking at Coordinates, you can directly set where the origin is from the lower left corner of the drawing. There is also a popup with commands that allow you to center it vertically and horizontally. You can also set the origin to the center of the selection.
In your dropbox image, the center line is selected. You can simply navigate to Documents/Coordinates and use the Set Origin popup to center the origin on the middle of this line.