If I draw a rectangle and rotate it from lying down to a more vertically standing position it wil change but I´ll get no info in the inspector showing the exact angle Ive changed to.
(If id made a line instead I would get info about the lines direction.)
Now lets say id like to mark that first and now standing rectangle to drag in a marker to make it longer. The logical place to drag it would be the upper or lower middle marker, but that wont work. The object, no matter how its oriented reacts as if it wasnt rotated at all and the original setting was unchanged.
So this now standing tall rectangle needs to be pulled in one of its middle side markers to be made longer because when I first drew it it was lying down.
After some time of duplication and alteration of objects this gets quite confusing. Its hard to tell in advance what exactly will happen if you try dragging an objects markers.
Running LXBeams Version 3.1.1 (77A29)
Rotated objects.
-
Johan Söderberg
- Posts: 294
- Joined: Mon Sep 01, 2008 12:35 pm
- Contact:
-
Johan Söderberg
- Posts: 294
- Joined: Mon Sep 01, 2008 12:35 pm
- Contact:
Now using: Version 3.1.9 (8015A)
I still have the problem that the handles of a rotated object end up far from the object itself.
Im drawing a stage where lots of pipes are in a 45 degree angle and these get marked wherever I click in my plot. The handles show up far from the object so quite often I happen to move these lines around unintentionally.
I still have the problem that the handles of a rotated object end up far from the object itself.
Im drawing a stage where lots of pipes are in a 45 degree angle and these get marked wherever I click in my plot. The handles show up far from the object so quite often I happen to move these lines around unintentionally.
