Send a line to back

TvH · Post by **TvH** » Tue Sep 18, 2018 10:12 am

How can i send a simple line to back - means to not go through the lamps?

Post by **admin** » Tue Sep 18, 2018 1:01 pm

Use the Format -> Arrange -> Send to Back menu command.

TvH · Post by **TvH** » Tue Sep 18, 2018 1:45 pm

admin wrote:Use the Format -> Arrange -> Send to Back menu command.

i tried this but it still is visable trough the lamps...

Post by **admin** » Tue Sep 18, 2018 2:31 pm

Are the light symbols and the line on different layers? The Send to Back command only sends the objects to the back of the current layer.

You can drag the layers into a different order using the Inspector's Layers tab.

The order of the layers shown in the Inspector's Layers tab is either top-to-bottom or bottom-to-top depending on the small up or down icon in the header of the layers table.

TvH · Post by **TvH** » Tue Sep 18, 2018 4:18 pm

sorry for bothering you and many thanks for quick reply...
Fill at full was the solution - sorry...